Sounds like a new metamaterial could enhance acoustic imaging

Researchers from North Carolina State University (NC State) and Duke University have developed a metamaterial made of paper and aluminum that can manipulate acoustic waves at more than double the resolution currently possible for acoustic imaging. The novel metamaterial can also focus acoustic waves and control the angles at which sound passes through it. Acoustic imaging is used both for medical diagnostics and for testing the structural integrity of everything from airplanes to bridges.

"This metamaterial is something that we've known is theoretically possible, but no one had actually made it before," says Yun Jing, an assistant professor of mechanical and aerospace engineering at NC State and corresponding author of a paper in Physical Review Letters describing the work.

Metamaterials are materials that have been engineered to exhibit properties not found in nature. In this case, the structural design of the metamaterial gives it qualities that make it a ‘hyperbolic’ metamaterial, meaning it interacts with acoustic waves in two different ways. From one direction, the metamaterial exhibits a positive density and interacts with acoustic waves normally – just like air. From a perpendicular direction, however, the metamaterial exhibits a negative density in its interaction with sound. This effectively makes acoustic waves bend at angles that are the exact opposite of what basic physics would tell you to expect.

This hyperbolic property means the metamaterial has some very useful applications. For one thing, it can be used to improve acoustic imaging. Traditionally, acoustic imaging could not achieve image resolution that was smaller than half of a sound's wavelength. For example, an acoustic wave of 100 kilohertz (kHz) traveling through air has a wavelength of 3.4mm, so it couldn't achieve image resolution smaller than 1.7mm.

"But our metamaterial improves on that," explains Chen Shen, a PhD student at NC State and lead author of the paper. "By placing the metamaterial between the imaging device and the object being imaged, we were able to more than double the resolution of the acoustic imaging – from one-half the sound's wavelength to greater than one-fifth."

The metamaterial can also focus acoustic waves, making it a flexible tool. "Medical personnel and structural engineers sometimes need to focus sound for imaging or therapeutic purposes," Jing says. "Our metamaterial can do that, or it can be used to improve resolution. There are few tools out there that can do both."

Lastly, the metamaterial gives researchers more control over the angle at which acoustic waves can pass through it. "For example, the metamaterial could be designed to block sound from most angles, leaving only a small opening for sound to pass through, which might be useful for microphones," Shen says. "Or you could leave it wide open – it's extremely flexible."

Right now, the prototype metamaterial is approximately 30cm², and is effective for sounds between 1kHz and 2.5kHz. "Our next steps are to make the structure much smaller and to make it operate at higher frequencies," Jing says.

This story is adapted from material from North Carolina State University, with editorial changes made by Materials Today. The views expressed in this article do not necessarily represent those of Elsevier. Link to original source.