TAT Technologies has set the dates for its PM sintering courses that are designed to cover the fundamental and advanced aspects of the entire sintering process.

The courses will run as follows:

Preparation for better sintering: 17– 20 March

Covering all aspects of preparation of parts and the furnace before sintering, this course will give attendees a clear understanding of what is needed to ensure parts will be properly and thoroughly delubed, oxide reduced and graphite diffused before proceeding to the sintering section of the furnace.

Sintering – ferrous PM: 23– 26 March

Building off the knowledge and skills gained in the previous course, this will teach students how to guide their well-prepared part through the furnace and achieve a quality sintered result with the least property variation and at higher production rates. Course one is a prerequisite for this course.

For more information go here.

This story uses material from TAT Technologies, with editorial changes made by Materials Today. The views expressed in this article do not necessarily represent those of Elsevier.