The MPIF is running its PM post-sintering seminar in September for the first time in ten years.

The seminar will cover:

  • Essential information needed to improve the properties of final PM parts through better secondary and finishing operations
  • Increased productivity by reducing rework and scrap
  • Insight into the capabilities of the latest equipment
  • Knowledge to identify the source of problems – was it a sintering problem or a post-sintering operation problem?
  • A glimpse into where future trends are heading
  • Working knowledge from industrial experts.

It runs from 22–23 September at Penn State University, Pennsylvania, USA. For more information go here (pdf).

This story is reprinted from material from the MPIF, with editorial changes made by Materials Today. The views expressed in this article do not necessarily represent those of Elsevier.